Designed primarily for small and business users, the HP OfficeJet 8610 Printer is a wireless multifunction printer. So it is a cheap 123 hp com / oj8610 printer and offers better performance. You can print, scan, copy and fax at a lower cost. “HP Officejet Pro 8610 Wireless Setup” is not easy for all. HP OfficeJet 8610 supports WiFi and WiFi Direct, but the Ethernet connection is not supported. It is an office-centric printer and supports two-sided printing with an automatic document feeder. It also produces high-quality photos with a higher yield rate. To configure the printer, follow these instructions.
Wireless Setup Requirements
If you are setting your HP OfficeJet 8610 for the first time, examine the following information. Generally, you can find a set of defined instructions along with the printer package.
For that, an active 802.11 compliant Wi-Fi network and can be your personal network. Then, the Mac computer is linked with the same network either using Wi-Fi or an Ethernet cable.
If you have the above-mentioned printer requirements, you are ready to set up the HP OfficeJet 8610 printer on a wireless setup on a Mac computer.
Switch on your HP OfficeJet 8610 printer by pressing the power button. Then, Make sure that you turn on the ink cartridges installed before setting up the wireless connection.
Get rid of all the packing materials from the printer as the packing materials will be found both inside and outside the printer.
Wireless Setup Process
Keep the HP OfficeJet 8610 in a flat place in peace. Make the power cord connections before turning on the printer.
Insert a stack of paper inside the input tray and slide the paper guides inward until they rest against the edges of the paper.
Get rid of the ink cartridges from the packaging and pull the tab to remove the Orange protective tape, ink cartridge access door opening, and then install the ink cartridges into their respective slots. Close the access door ink cartridge and wait for the alignment page to print.
The print side of the page should be put down with the alignment on the right front corner of the scanner glass. Now you have to start copying black to align the ink cartridges. The hardware setup of the HP OfficeJet 8610 printer is set up successfully and prepared for the wireless configuration.
Now it's time to restore the default settings on the HP OfficeJet 8610 wireless printer. To reset the wireless setting, press a series of buttons on the printer control panel to complete the connection setup successfully.
Switch on the HP OfficeJet 8610 printer. If the wireless light is flashing, skip to the next step to install the HP OfficeJet 8610 printer software. Press and hold the power button. Release the power button after pressing the start copy black twice and then clicking Cancel thrice.
The wireless light on the side of the wireless button should blink. If the HP OfficeJet 8610 is not blinking, do the same times recurrently.
Instantaneously advance to the next step to install the HP software OfficeJet 8610. You have about 120 minutes to complete HP OfficeJet 8610 software setup using the HP OfficeJet 8610 wireless auto-connect features.
Now install the software from support.hp.com or 123.hp.com/oj8610 and enter your model number.
So these are the steps for “123.hp.com/setup 8610”. If you are not able to set up you can call our customer care number for expert advice.
Comments